DeWalt DCD985 Instrukcja Obsługi

DCD985-XE 18 V HEAVY-DUTY 13 mm (1/2") CORDLESS HAMMERDRILL/DRILL/DRIVERINSTRUCTION MANUAL

8Worklight (Fig. 2)There is a worklight (C) located just above the trigger switch (A). The worklight is activated when the trigger switch is depressed

9SCREWDRIVING (FIG. 4)Rotate the mode control collar (F) so the screw symbol is aligned with the arrow.NOTE: The torque adjustment collar may be set t

10WARNING: To reduce the risk of serious personal injury, DO NOT suspend tool overhead or suspend objects from the belt hook. ONLY hang tool’s belt ho

11 2. Rotate the mode control collar (F) so the screw symbol is aligned with the arrow. 3. Make a few practice runs in scrap or unseen areas of the

12MAXIMUM RECOMMENDED CAPACITIESDCD985-XEWOODAuger 32 mm (1-1/4")Paddle 38 mm (1-1/2")Twist 13 mm (1/2") Self-feed 65 mm (2-9/16")

Stanley Black & Decker701 East Joppa Road, Baltimore, MD 21286 • 82 Taryn Drive, Epping, VIC 3076 Australia (MAR11) Part No. N106260 DCD

1Definitions: Safety Guidelines The definitions below describe the level of severity for each signal word. Please read the manual and pay attention to

2c) Prevent unintentional starting. Ensure the switch is in the off position before plugging in. Carrying power tools with your finger on the switch

3 • Replacement of the supply cord. If the supply cord is damaged, it must be replaced by the manufacturer or an authorised DEWALT Service Centre in

4 • NEVER force the battery pack into the charger. DO NOT modify the battery pack in any way to fit into a non-compatible charger as battery pack may

5 • If battery contents come into contact with the skin, immediately wash area with mild soap and water. If battery liquid gets into the eye, rinse wa

6Charging Procedure (Fig. 1) FIG. 1I 1. Plug the charger into an appropriate outlet before inserting the battery pack. 2. Insert the battery pack (

7 c. Move the charger and battery pack to a location where the surrounding air temperature is approximately 18° – 24°C (65°F and 75°F); d. If