DC490, DC495, DW940, DW941 CORDLESS SWIVEL HEAD SHEARSINSTRUCTION MANUAL
8To remove the battery pack from the tool, press the release buttons (F) and firmly pull the battery pack out of the tool handle. Insert it into the c
9DC490, DW940, DW941 (FIG. 1, 5, 6)To remove shear head from motor, loosen three cap screws (G) using the hex wrench (D) provided. Remove shear head (
10To remove cutter blades from the shear head, completely loosen the two back cap screws and remove shear head from motor unit. Loosen the tensioning
11DC490, DW940, DW941To adjust the curl of waste material, the left side knife has elongated holes. Adjustment may be necessary after changing blades
12Recommended accessories for use with your tool are available at extra cost from your local service center. If you need any assistance in locating an
DEWALT Battery and Charger SystemsBattery Output Chargers/Charge TimeNominal 240 Volts 12 VoltsX Indicates that the battery pack is not compatible wi
FIG. 1AEBCDFDC495AEBCDFDC490ACEBDFDW940, DW941
1IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS OR ANY DEWALT TOOL, CALL US AT: 1800 654 155 (Aust) or 09 259 1111 (NZ).SAFETY INSTRUCTIONS FOR POWE
2d. Remove any adjusting key or wrench before turning the power tool on. A wrench or a key left attached to a rotating part of the power tool may re
3Extension CordsCAUTION: Use only extension cords that are approved by the country’s Electrical Authority. Before using extension cords, inspect them
4The RBRC™ SealThe RBRC™ (Rechargeable Battery Recycling Corp oration) Seal on the nickel cadmium and nickel metal hydride batteries (or battery pack
5charger cavities. Always unplug the charger from the power supply when there is no battery pack in the cavity. Unplug charger before attempting to cl
6SAVE THESE INSTRUCTIONS FOR FUTURE USEChargers Your tool uses a DEWALT charger. Your battery can be charged in DEWALT 1 Hour Chargers, 15 Minute Cha
7b. Check to see if receptacle is connected to a light switch which turns power off when you turn out the lights. c. Move charger and battery pack
Komentarze do niniejszej Instrukcji